Codes: #P303-Cylinder 3 Misfire Detected Removed #3 spark plug, found it fouled with oil again. Cleaned plug and re-installed and cleared code. Oil getting past piston rings causing plug to foul out. Needs an engine to fix problem.
PRISCILLA F. gave our service a 5 star review on 6/4/2024
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels, tire pressures and test vehicle battery.
Remove engine covers, access tensioner, and remove old drive belt. Check all pulleys for wear and proper function. Route and install new serpentine belt and adjust to correct tension.
AAA DISCOUNT
KIMBERLY A. gave our service a 5 star review on 5/14/2024
CHECK LEFT REAR TIRE FOR A LEAK Repair left rear tire
Support glass and disassemble/remove door panel to access and disconnect regulator/motor removing from door. Clean contact points, lubricate, and install new regulator. Reinstall previous components, program, and test functions confirming repairs.
STEVE G. gave our service a 5 star review on 3/15/2024
Codes: # P0301 -Indicates that the powertrain control module (PCM) has counted enough misfire events on cylinder 1
Remove engine covers, disconnect wiring harnesses, and remove ignition coils to access and remove old plugs from front and rear of engine. Clean and inspect tube seals. Replace spark plugs, ignition coils, and reinstall previous components.
NATALIE H. gave our service a 5 star review on 3/4/2024
Support right side of engine and disconnect vacuum hoses. Remove bolts and brackets to extract old mount assembly. Clean, lubricate, install new mount, and reinstall previous components.
Access hose, remove clamps, and disconnect mass air flow sensor. Extract old hose and clean mating surfaces before installing new air intake hose.
Remove front wheels to gain access to brake assemblies. Depress hydraulic brake pistons- remove pads from calipers. Remove brake calipers to access and remove rotors. Replace pads and rotors.
Clean, inspect for damage or wear and lubricate.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Raise vehicle, remove wheel, and unfasten splash shields and fender liner to separate old axle from hub and transaxle. Clean surface areas free of debris. Install new axle shaft, reinstall previous components, and road test vehicle.
RAYMOND T. gave our service a 5 star review on 2/27/2024