Codes: # P0301 -Indicates that the powertrain control module (PCM) has counted enough misfire events on cylinder 1
Remove engine covers, disconnect wiring harnesses, and remove ignition coils to access and remove old plugs from front and rear of engine. Clean and inspect tube seals. Replace spark plugs, ignition coils, and reinstall previous components.
NATALIE H. gave our service a 5 star review on 3/4/2024
CUSTOMER NEEDS PRICING ON PASSENGER FRONT HEADLIGHT BULB, PASSENGER REAR CORNER LENS ASSEMBLY, AND AN OIL CHANGE
Raise vehicle, remove paneling, and disconnect wiring remove old lens from bumper. Clean mounting area, install new tail lamp, and reinstall previous components.
Apply air pressure to cooling system- Inspect radiator, all coolant lines and connections for leaks and discrepancies. Locate leak and issue coming from the thermostat housing needing to be replaced.
Customer did not want HID headlamp bulb replaced
Front lower rearward control arms are extremely worn and should be replaced ASAP
JAMES P. gave our service a 5 star review on 2/29/2024
-Inspect calipers, pads, rotors, brake lines and all fittings for wear, corrosion, leaks or any unsafe condition. Could not duplicate customers issue. Brakes and rotors are new on vehicle.
GABRIEL H. gave our service a 5 star review on 2/29/2024
Support right side of engine and disconnect vacuum hoses. Remove bolts and brackets to extract old mount assembly. Clean, lubricate, install new mount, and reinstall previous components.
Access hose, remove clamps, and disconnect mass air flow sensor. Extract old hose and clean mating surfaces before installing new air intake hose.
Remove front wheels to gain access to brake assemblies. Depress hydraulic brake pistons- remove pads from calipers. Remove brake calipers to access and remove rotors. Replace pads and rotors.
Clean, inspect for damage or wear and lubricate.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Raise vehicle, remove wheel, and unfasten splash shields and fender liner to separate old axle from hub and transaxle. Clean surface areas free of debris. Install new axle shaft, reinstall previous components, and road test vehicle.
RAYMOND T. gave our service a 5 star review on 2/27/2024